WatchGuard Technologies WatchGuard SOHO and SOHO | tc - Manual (Page 14)

Performing manual installation
2
• An operational Internet connection.
Setup of your SOHO requires access to the Internet. If your
connection does not work, please contact your Internet
service provider (ISP). When your connection has been
established, you may proceed with installation and setup.
• If you have either a cable or DSL modem, consult the manual
that came with your service, or call the ISP to find out
whether your particular modem supports DHCP or PPPoE.
You will need this information later in the installation
process.
• If you are using PPPoE to connect to your local Internet
service provider, the WatchGuard SOHO must be running
firmware version 2.0 or later.
• An installed Web browser–either Netscape Navigator 4.5
(or higher) or Internet Explorer 4.0 (or higher).
• SOHO serial number.
Performing manual installation
Before you begin the installation process, connect to the Internet.
You need to determine your current TCP/IP settings and disable
your HTTP proxy.
Determine your current TCP/IP settings
For your reference, record the your computer’s current TCP/IP
settings in the chart provided at the end of this section. Different
operating systems will supply different information. To locate your
settings: