WatchGuard Technologies WatchGuard SOHO and SOHO | tc - Manual (Page 19)

User Guide 2.3 7
Physically connecting your SOHO
1 Complete the “Pre-installation checklist” on page 1.
2 Turn off your computer.
3 Unplug the power from your cable or DSL modem.
4 Unplug the Ethernet cable that is connected from your cable or
DSL modem to your computer. Connect it from your modem
to the WAN port on the SOHO.
This creates a connection between the SOHO and the modem.
5 Plug the Ethernet cable supplied with your SOHO into any one
of the numbered (1-4) ports on the SOHO. Plug the other end
into the Ethernet card installed in your computer.
This creates a connection between your modem and computer, with the
SOHO in between. If you have additional computers, use additional
Ethernet cables to connect them to the other numbered ports on the
SOHO.