Technical, How do i reboot my soho, How do i set up my soho for remote configuration – WatchGuard Technologies WatchGuard SOHO and SOHO | tc User Manual
Page 42: How do i reset the soho to factory defaults
Troubleshooting installation and network configuration
30
3
Click VPN Configuration.
4
Click Configuring a SOHO to SOHO IPSec VPN Tunnel.
5
Download and follow the instructions to configure your VPN
tunnel.
TECHNICAL
How do I reboot my SOHO?
1
Using your Web browser, go to http://192.168.111.1.
2
Click System Information.
3
Click Features and Version Information.
4
Click Reboot and wait for the SOHO to finish rebooting. The
MODE light on the front of the SOHO will turn off, then back
on.
You can also reboot by removing the power source for ten seconds, and
then restoring power.
How do I set up my SOHO for remote configuration?
This requires the add-on product, WatchGuard VPN Manager
software, which is purchased separately. To purchase VPN
Manager, go to:
https://www.watchguard.com/products/vpnmanager.asp
For more information on how to remotely configure a SOHO, see
the VPN Manager Guide.
How do I reset the SOHO to factory defaults?
To reset the SOHO to factory settings, disconnect the power,
disconnect all cables, plug one end of an Ethernet cable into the
WAN port and the other end into any LAN port, connect power,
wait 90 seconds, and disconnect power. Your SOHO is now reset to