How do i change to a static private ip address, How do i allow any incoming service – WatchGuard Technologies WatchGuard SOHO and SOHO | tc User Manual
Page 39
User Guide 2.3
27
Troubleshooting installation and network configuration
5
Click Reboot and wait for the SOHO to finish rebooting. The
MODE and ON light flash at different times during boot,
which takes about a minute.
How do I change to a static private IP address?
Before you can use a static IP address, you must have a base
Private IP address and subnet mask.
The following IP address ranges and subnet masks are set aside for
private networks in compliance with RFC 1918. Replace the X in
the network IP address with a number between 1 and 254. The
subnet addresses do not need to be changed.
To change to a static private IP address:
1
Using your Web browser, go to http://192.168.111.1.
2
Click Private Network, and disable the checkbox labeled
Enable DHCP Server.
3
Enter the information in the appropriate fields. Click Submit.
4
Click Reboot and wait for the SOHO to finish rebooting. The
MODE light on the front of the SOHO will turn off, then back
on.
How do I allow any incoming service?
With the SOHO, you can allow any incoming service but doing
this opens your network to the public.
Network IP range
Subnet mask
10.x.x.x
255.0.0.0
172.16.x.x
255.240.0.0
192.168.x.x
255.255.0.0