Worth Data RF Terminal 7000 User Manual
Page 10
be significantly shorter than when the device was new, the battery should be replaced. If you have the
optional “gun” handle with the extended battery then both batteries should be replaced at the same time. The
main battery is a common digital camera battery sold as Fujifilm NP-120 or Pentax D-LI7. We use a high
quality Japanese Li-Ion cell in our OEM pack that we supply with the RF Terminal. You can obtain a
replacement from Worth Data (P/N: L02) . Our pack is rated at 1950 mAh and provides the longest runtime
available. Do not use a battery pack of unknown quality or origin. Doing so can risk damage to your unit.
The optional handle battery is custom made for Worth Data and must be ordered from us.
Your old battery should be recycled. You can get free recycling information at:
To change the internal battery:
1. Turn OFF the RF Terminal.
2. Remove the battery holder door on the back of the RF Terminal by removing the two screws holding the
door in place..
3. Remove the old battery and insert a new one, making sure to orient the battery with the battery
contacts facing the battery connector.
4. To replace the optional handle battery, remove the 2 screws holding the handle in place. Unplug the
handle battery assembly.
5. Replace the battery door and screws and turn the reader on using the ON/OFF switch.
6. Sign ON and resume your application.
Recharging the battery:
1. With the RF Terminal shut off, plug the 5V power adapter into the RF Terminal using the supplied
adapter cable.
2. The RF Terminal will turn On and display the following message:
Charging Battery
Please Wait………..
3. When the battery is fully charged after 2-4 hours the following messaged is displayed:
Battery Charge
Complete
4. The unit will remain ON for a half hour or so after the charge cycle has completed and then turn
OFF.
5. If you press the POWER key while the unit is charging, nothing will happen.
6. If you press the POWER key after the unit has turned OFF after completing a charge cycle and the
charger is still attached, the “Charging Battery” message will display again and a charge cycle will
begin.
7. It will take about 2 hours to fully charge a unit with a single battery and about 4 hours to fully charge
a unit with the optional handle battery.
8. Do not charge the battery if the Terminal is very hot or very cold since this will give a false reading
on the condition of the battery and it may not get charged properly.
9. You cannot operate the unit when the charger is attached, except to charge the battery.