Worth Data RF Terminal 7000 - Manual (Page 24)

or F1 to exit.
Beep Tone
1 - Lowest 2
2 - Low 2
3 - Medium 2
4 - High 2
5 - Highest 2
The default beep tone is 3 – Medium. Each time you press the “2” key you will hear a beep at
various tones. When you are happy with the tone of the beep, press 0 or F1 to exit.
Voice Volume
OFF 3
Low 3
Medium 3
High 3
The default volume of the “Voice” is Medium. Unless you need very loud voice prompts you should
use the medium setting to conserve battery power. When you are happy with the loudness of the
beep tone, press 0 or F1 to exit.
Keypad Tone
Keypad Tone ON OFF 4
The “Keypad Tone” is the key click that you hear each time a key is pressed. Press the “4” key to
toggle this On and Off.
Laser Options
Double Decode
Double Decode ON OFF 1
• Double Decode is there to minimize the possibility of misreads when scanning very poor quality bar codes. This
option forces the RF Terminal to keep reading until it gets two results that are identical. This "double scan
checking" takes longer but will minimize misreads since it must get the same result twice before considering it a
"good" read.
4.5 Second Laser Beam
4.5 Second Laser Beam ON OFF 2
• 4.5-second laser beam increases the amount of time the laser beam is activated, giving the laser more time to try
and read a code. This option is useful for trying to read poor quality code. The default beam time is 2 seconds.
Aiming Dot Duration
Aiming Dot Duration (in 1/10 seconds) 00 – 99 3
• This parameter applies to the built-in internal laser. Before the laser beam spreads, you can create a brighter
aiming dot to be sure you are on the bar code you want to read. The default is set to 00, no aiming dot. You
can key in 01 through 99 which creates an aiming dot in 1/10th second increments; i.e., 20 would be two
seconds.
• This option is only available on the LT7001.