Worth Data RF Terminal 7000 - Manual (Page 64)

the end key on the terminal. A termID+CR will be sent to the host.
InputYesNo
Parameters: basename, channel, terminal, line, position, prompt
Function:
This instructs the terminal attached to client basename on channel to display the prompt
at line and position and wait for a Yes (Enter key or C key) or a No (0 key or B key)
from the terminal keypad.
Note: C and B keys are used to facilitate keypad entry while scanning with the
integrated laser.
InputPassword
Parameters: basename, channel, terminal, line, position, prompt, shifted
Function:
This instructs the terminal attached to client basename on channel to display the prompt
at line and position and wait for data to be entered from the terminal keypad only. The
entered data is not displayed on the terminal.
InputSerial
Parameters: basename, channel, terminal, line, position, prompt
Function:
This instructs the terminal attached to client basename on channel to display the prompt
at line and position and wait for data to be received through the terminal serial port.
Waiting for serial input can be bypassed by pressing the enter key on the terminal which
will send an empty data string to the host (fires the
OnTermData
event handler).
OutputSerial
Parameters: basename, channel, terminal, data
Function:
This instructs the terminal attached to client basename on channel to send data to the
terminal’s serial port. Data must be less than 231 characters in length for each call to
OutputSerial
.
SendDisplay
Parameters: basename, channel, terminal, line, position, prompt
Function:
This instructs the terminal attached to client basename on channel to display the prompt
at line and position. Must be followed by an "
Input
" method call to take effect.
ClearScreen
Parameters: basename, channel, terminal
Function:
This instructs the terminal attached to client basename on channel to clear its display.
Must be followed by an "
Input
" method call to take effect.
ClearLine
Parameters: basename, channel, terminal, line
Function:
This instructs the terminal attached to client basename on channel to clear the specified
line on its display. Must be followed by an "
Input
" method call to take effect.
SendDate
Parameters: basename, channel, terminal, line
Function:
This instructs the terminal attached to client basename on channel to display date and
time on the specified line number. Must be followed by an "Input" method call to take
effect.
Beep
Parameters: basename, channel, terminal, count
Function:
This instructs the terminal attached to client basename on channel to beep count times.
Count may be a value from 1 to 9. Must be followed by an "Input" method call to take