ZyXEL Communications P-2602HW(L) Series - Manual (Page 312)

P-2602H(W)(L)-DxA Series User’s Guide
312 Chapter 25 Tools
0 config.rom” transfers the configuration file on the device to your computer and renames
it “config.rom.” See earlier in this chapter for more information on filename conventions.
7 Enter “quit” to exit the ftp prompt.
25.9.2 FTP Session Example of Firmware File Upload
Figure 182 FTP Session Example of Firmware File Upload
More commands (found in GUI-based FTP clients) are listed earlier in this chapter.
Refer to Section 25.3 on page 302 to read about configurations that disallow TFTP and FTP
over WAN.
25.9.3 TFTP File Upload
The device also supports the uploading of firmware files using TFTP (Trivial File Transfer
Protocol) over LAN. Although TFTP should work over WAN as well, it is not recommended.
To use TFTP, your computer must have both telnet and TFTP clients. To transfer the firmware
and the configuration file, follow the procedure shown next.
1 Use telnet from your computer to connect to the device and log in. Because TFTP does
not have any security checks, the device records the IP address of the telnet client and
accepts TFTP requests only from this address.
2 Enter the command “sys stdio 0” to disable the management idle timeout, so the TFTP
transfer will not be interrupted. Enter “command sys stdio 5” to restore the five-minute
management idle timeout (default) when the file transfer is complete.
3 Launch the TFTP client on your computer and connect to the device. Set the transfer
mode to binary before starting data transfer.
4 Use the TFTP client (see the example below) to transfer files between the device and the
computer. The file name for the firmware is “ras”.
331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> put firmware.bin ras
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 1103936 bytes sent in 1.10Seconds
297.89Kbytes/sec.
ftp> quit