ZyXEL Communications P-2602HW(L) Series - Manual (Page 262)

P-2602H(W)(L)-DxA Series User’s Guide
262 Chapter 19 Bandwidth Management
19.9 Bandwidth Monitor
To view the ZyXEL Device’s bandwidth usage, click Advanced > Bandwidth MGMT >
Monitor. The screen appears as shown. Select an interface from the drop-down list box to
view the bandwidth usage of its bandwidth rules. The gray section of the bar represents the
percentage of unused bandwidth and the blue color represents the percentage of bandwidth in
use.
Figure 139 Bandwidth Management: Monitor
Source Subnet
Netmask
Enter the destination subnet mask. This field is N/A if you do not specify a
Source Address. Refer to the appendix for more information on IP subnetting. A
blank source port means any source port number.
Source Port Enter the port number of the source. See Appendix 31 on page 371 for some
common services and port numbers.
Protocol Select the protocol (TCP or UDP) or select User defined and enter the protocol
(service type) number. 0 means any protocol number.
Back Click Back to go to the previous screen.
Apply Click Apply to save your changes back to the ZyXEL Device.
Cancel Click Cancel to begin configuring this screen afresh.
Table 103 Bandwidth Management Rule Configuration (continued)
LABEL DESCRIPTION