Figure 136 bandwidth management: summary, Table 101 media bandwidth management: summary – ZyXEL Communications P-2602HW(L) Series User Manual

Page 258

Advertising
background image

P-2602H(W)(L)-DxA Series User’s Guide

258

Chapter 19 Bandwidth Management

Enable bandwidth management on an interface and set the maximum allowed bandwidth for
that interface.

Figure 136 Bandwidth Management: Summary

The following table describes the labels in this screen.

Table 101 Media Bandwidth Management: Summary

LABEL

DESCRIPTION

Interface

These read-only labels represent the physical interfaces. Select an interface’s check

box to enable bandwidth management on that interface. Bandwidth management

applies to all traffic flowing out of the router through the interface, regardless of the

traffic’s source.
Traffic redirect or IP alias may cause LAN-to-LAN traffic to pass through the ZyXEL

Device and be managed by bandwidth management.

Active

Select an interface’s check box to enable bandwidth management on that interface.

Speed

(kbps)

Enter the amount of bandwidth for this interface that you want to allocate using

bandwidth management.
This appears as the bandwidth budget of the interface’s root class. The

recommendation is to set this speed to match the interface’s actual transmission speed.

For example, set the WAN interface speed to 1000 kbps if your Internet connection has

an upstream transmission speed of 1 Mbps.
If this number is higher than the interface’s actual transmission speed, and you

configure bandwidth rules for all of the bandwidth, higher priority traffic could use all of

the bandwidth so lower priority traffic does not get through.

Note: Unless you enable Max Bandwidth Usage, the ZyXEL Device

only uses up to the amount of bandwidth that you configure here.
The ZyXEL Device does not use any more bandwidth for the
interface’s connections, even if the interface has more outgoing
bandwidth.

Scheduler

Select either Priority-Based or Fairness-Based from the drop-down menu to control

the traffic flow.
Select Priority-Based to give preference to bandwidth classes with higher priorities.
Select Fairness-Based to treat all bandwidth classes equally.

Advertising
This manual is related to the following products: