ZyXEL Communications P-2602HW(L) Series - Manual (Page 390)

P-2602H(W)(L)-DxA Series User’s Guide
390 Appendix I Log Descriptions
The following table shows RFC-2408 ISAKMP payload types that the log displays. Please
refer to RFC 2408 for detailed information on each type.
Log Commands
Go to the command interpreter interface ( Appendix J on page 393 explains how to access and
use the commands).
Configuring What You Want the ZyXEL Device to Log
1 Use the sys logs load command to load the log setting buffer that allows you to
configure which logs the ZyXEL Device is to record.
2 Use sys logs category to view a list of the log categories.
Figure 221 Displaying Log Categories Example
3 Use sys logs category followed by a log category to display the parameters that are
available for the category.
Table 172 RFC-2408 ISAKMP Payload Types
LOG DISPLAY PAYLOAD TYPE
SA Security Association
PROP Proposal
TRANS Transform
KE Key Exchange
ID Identification
CER Certificate
CER_REQ Certificate Request
HASH Hash
SIG Signature
NONCE Nonce
NOTFY Notification
DEL Delete
VID Vendor ID
Copyright (c) 1994 - 2004 ZyXEL Communications Corp.
ras> ?
Valid commands are:
sys exit ether wan
wlan ip bridge lan
radius 8021x dsp voiceradius 8021x
ras>