Xerox DocuColor 7000 EN - Manual (Page 151)

DocuColor 8000/7000 Operator Manual 5-5
5. Technical Data
Print Rates
Use the Productivity Setting in the Tools Mode to optimize the
throughput speed for the weight of the paper you are using.
•
Selecting
Single Paper Weight
sets the Fuser temperature to
160
o
C, which optimizes the throughput speed for light and
heavy weight papers, according to the weight range that is set
in the paper tray, and uses less power.
• Selecting
Mixed Paper Weight
sets the Fuser temperature to
175
o
C, which optimizes the throughput speed for mixed paper
weights from different paper trays, and uses more power.
Refer to the
System Administrator Guide
for the procedure to
change the setting.
The following chart illustrates the print speeds for the two modes
using 8.5x11” or A4 paper fed LEF.
:
*ppm = prints per minute
DocuColor 8000/7000
Substrate
DocuColor 8000 DocuColor 7000
Single Paper
Weight
Mixed Paper
Weight
Single Paper
Weight
Mixed Paper
Weight
1 Sided 2 Sided 1 Sided 2 Sided 1 Sided 2 Sided 1 Sided 2 Sided
60 - 80 g/m
2 80 ppm 40 ppm 80 ppm 40 ppm 70 ppm 35 ppm 70 ppm 35 ppm
81 - 105 g/m 2 80 ppm 40 ppm 80 ppm 40 ppm 70 ppm 35 ppm 70 ppm 35 ppm
106 - 135 g/m 2 80 ppm 40 ppm 60 ppm 30 ppm 70 ppm 35 ppm 60 ppm 30 ppm
136 - 186 g/m
2 60 ppm 30 ppm 60 ppm 30 ppm 50 ppm 25 ppm 50 ppm 25 ppm
187 - 220 g/m 2 60 ppm 30 ppm 40 ppm 20 ppm 50 ppm 25 ppm 40 ppm 20 ppm
221 - 300 g/m 2 40 ppm ------- 40 ppm ------ 35 ppm ------- 35 ppm ------
Transparencies 30 ppm ------- 30 ppm ------ 30 ppm ------- 30 ppm ------