Yamaha TSS-10 - Manual (Page 17)

15
TROUBLESHOOTING
English
APPENDIX
Problem
Though a Dolby
Digital encoded
source is inputted to
this system and the
DIGITAL mode is
selected, no sound is
outputted from the
center and rear
speakers.
A DTS or Dolby
Digital encoded
source cannot be
played in the DTS or
DIGITAL mode.
(Neither the DTS nor
DIGITAL mode
indicator lights up.)
Sound is distorted.
Noise.
The remote control
does not work nor
function properly.
Cause
A Dolby Digital 2-channel encoded source is
inputted to this system.
The DVD player, etc. sending the playback
signal to this system is not set as follows.
• “Digital output” and “DTS or Dolby Digital
mode”
• “Output: Digital” and “Signal type: DTS or
Dolby Digital”
The level of the input signal is too high.
The level of the input signal is too low.
Connections are faulty or incomplete.
The amplifier unit is too close to the monitor.
Wrong distance or angle.
Direct sunlight or lighting (from an inverter
type of fluorescent lamp, etc.) is striking the
remote control sensor of the amplifier unit.
The batteries are weak.
Remedy
If the input source is compatible with 5.1
channels, select “5.1-channel mode” on the
player which is sending signals to this system.
(If the input source is not compatible with 5.1
channels, you can enjoy the source in a multi-
channel mode by using the
PL II MOVIE
or MUSIC surround mode.)
Make a proper setting on the DVD player, etc.
referring to the instruction manual of the player.
Turn down the output level on the connected
component.
Turn up the output level on the connected
component.
Make the connections again.
Place the amplifier unit away from the monitor.
The remote control will function within a
maximum range of 6 m (20 feet) and no more
than 30 degrees off-axis from the front panel.
Reposition the amplifier unit.
Replace all batteries with new ones.
Refer
to page
13
—
—
—
8 – 9
—
4
—
2
TSS-10Eng(UB)a 02.7.31, 2:35 PM 15