Yamaha TSS-10 - Manual (Page 7)

5
English
PREP
ARA
TION
System configuration
This system includes an amplifier unit, five speakers and
a subwoofer.
The three speakers with a 3 m cable are used as front
speakers and a center speaker.
The two speakers with a 10 m cable are used as rear
speakers.
The role of respective speakers
The front speakers are used for reproducing main channel
sound. The rear speakers are used for effect sounds, and
the center speaker is for center channel sound (dialog
etc.).
The subwoofer is used for reproducing sounds of low
frequencies from the front, center and rear surround
channels. The subwoofer also reproduces sounds of the
subwoofer channel when a DTS or Dolby Digital encoded
source is played.
Amplifier
unit
Subwoofer
Right front
speaker
Left front
speaker
Right rear
speaker
Left rear
speaker
Center
speaker
Recommended speaker placement
Before making connections, place all speakers in their
respective positions. The positioning of the speakers is
important because it controls the overall sound quality of
this system.
Place the speakers depending on your listening position
by following the instructions below.
* The front/center/rear speakers can be mounted on a wall. (See
the next page.)
Front speakers: On both sides of and at approximately
the same height as the TV.
Rear speakers: Behind your listening position or on
both sides of the listening room.
Center speaker: Precisely between the front speakers.
* The center speaker can be mounted
on the monitor as shown on the next
page.
Subwoofer: On the floor. The position of the
subwoofer is not so critical because
low bass tones are not highly
directional.
Note
• Although the speaker system in this system is magnetically
shielded, it may still affect the color on the television monitor
when using this system near the television. Adjust the relative
positions of this system and the television if this happens.
SETTING UP THE SYSTEM
Amplifier unit x 1 Speaker x 5 Subwoofer x 1
TSS-10Eng(UB)a 02.7.31, 2:35 PM 5