Yamaha TSS-10 - Manual (Page 6)

4
CONTROLS AND FUNCTIONS
■ Using the remote control
Handling the remote control
• Do not spill water or other liquids on the remote
control.
• Do not drop the remote control.
• Do not leave or store the remote control in the
following types of conditions:
– high humidity or temperature such as near a heater,
stove or bath;
– dusty places; or
– in places subject to extremely low temperatures.
3
VOLUME (+/–) and indicators
Used for adjusting the overall volume level of this system.
The current level is shown by the lighting of the
indicators on the front panel.
VOLUME on the front panel:
Turn this control clockwise to increase the level, and
counterclockwise to decrease the level.
VOLUME +/– on the remote control:
Press + to increase the level, and – to decrease the level.
4
Remote control sensor
Receives signals from the remote control.
5
STANDBY/ON ( ) and indicator
Each press of this button changes the status of this system
between standby mode and power on. When the power is
on, the indicator lights up.
Standby mode
In this mode, this system will consume a small amount
of power in order to receive infrared-signals from the
remote control.
6
SILENT
Stereo headphones can be connected to this mini-jack for
private listening. Sound output from the speakers is cut
off when headphones are connected to this jack.
7
REAR +/–
These buttons are used for adjusting the sound level from
the rear speakers. Press + to increase the level, and – to
decrease the level.
8
S.WOOFER +/–
These buttons are used for adjusting the sound level from
the subwoofer. Press + to increase the level, and – to
decrease the level.
9
MUTE
Press this button to cut off sound output temporarily.
Press this button again to restore sound output.
0
TEST
Press this button to reproduce a test tone from the
speakers. A test tone is reproduced from each speaker in
turn. The test tone is used for adjusting volume balance
among all the speakers. The adjustment is made by
pressing VOLUME +/– on the remote control.
SILENT
30 ° 30 °
Approximately 6 m (20 feet)
* The STANDBY/ON indicator
flashes while the amplifier
unit is receiving signals from
the remote control.
TSS-10Eng(UB)a 02.7.31, 2:35 PM 4