Yamaha TSS-10 - Manual (Page 8)

6
SETTING UP THE SYSTEM
Ⅵ Placing a center speaker on top of the
monitor
When placing the center speaker on top of the monitor,
remove the stand from the speaker, and attach the
provided fastener at the bottom of the speaker and on top
of the monitor to prevent the speaker from falling.
* Do not place the speaker on top of the monitor with an
inclination of more than 10 degrees.
Note
• Though this speaker is a magnetically shielded type, there may
be some influence on the monitor picture depending on the
type of monitor or the placement of the speaker. In such a case,
place the speaker further apart from the monitor until there is
no influence on the monitor picture.
Ⅵ Mounting the amplifier unit on the
supplied stand
For improved stability, it is recommended to mount the
amplifier unit on the supplied stand with the supplied
screws as shown below.
* Attach the supplied non-skid pads at the four corners on the
bottom of the stand for improved stability.
10
؇
10 ؇ Fastener
Ⅵ Adjusting the front angle of the front/
center/rear speakers
The front angle of the speakers can be adjusted as shown
below.
1 Loosen the screw on the bottom of the speaker stand.
* Attach the supplied non-skid pads at the four corners on
the bottom of the stand for improved stability.
2 Adjust the speaker angle on the stand as you prefer,
and then tighten the screw.
Ⅵ Mounting the front/center/rear speakers
on a wall
The speakers can also be hung on the wall.
Remove the stand from the speaker. Fasten screws into a
firm wall or wall support as shown in the figure, and hang
the slits on the rear of the speaker on the protruding
screws.
* Make sure that the screws are securely caught by the slits.
Warning
• Each speaker weighs 0.4 kg (0.9 lbs.). Do not mount them on
thin plywood or a wall with soft surface material. If mounted,
the screws may come out of the flimsy surface and the speakers
may fall. This could damage the speakers and cause personal
injury.
• Do not install the speakers on a wall with nails, adhesives, or
any other unstable hardware. Long-term use and vibrations
may cause them to fall.
• To avoid accidents resulting from tripping over loose speaker
cables, fix them to the wall.
Non-skid
pads
Tapping screw (Diam. 4 mm)
(Available in hardware stores)
50 mm
Min.
20 mm 5 mm
W
all/ wall
suppor
t
Non-skid
pads
TSS-10Eng(UB)a 02.8.1, 10:08 PM 6