Yamaha TSS-10 - Manual (Page 4)

2
CHECKING THE ACCESSORIES
Check your package to make sure it contains the following items.
Remote control Batteries
(AAA, R03, UM-4)
Power cable Non-skid pads
(3 sets: 24 pieces)
1
3
2
Screws
(2 pieces)
Optical cable Audio pin cable
AC adaptor
(LSE9802B1540)
Stand
(for the amplifier unit)
INPUT
MODE
REAR
MUTE TEST
S.WOOFER
VOLUME
INSTALLING BATTERIES IN THE REMOTE CONTROL
3.5 mm stereo mini/
RCA stereo pin cable
Fastener (1 set)
(for the center speaker)
Insert the batteries in the correct direction by aligning the
+ and – marks on the batteries with the polarity markings
(+ and –) inside the battery compartment.
1 Press the part and slide off the
battery compartment cover.
2 Insert the two batteries (AAA, R03, UM-4
type) with + and – oriented properly.
The batteries can be set only from the direction
shown in the figure.
3 Slide the cover back on so that it snaps into
place.
■ Notes on batteries
• Change all of the batteries if you notice a decrease in
the operating range of the remote control.
• Do not use old batteries together with new ones.
• Do not use different types of batteries (such as alkaline
and manganese batteries) together. Read the packaging
carefully as these different types of batteries may have
the same shape and color.
• If the batteries have leaked, dispose of them
immediately. Avoid touching the leaked material or
letting it come into contact with clothing, etc. Clean the
battery compartment thoroughly before installing new
batteries.
TSS-10Eng(UB)a 02.7.31, 2:34 PM 2