Using trigger out jacks for multi-zone components – Yamaha RX-Z7 User Manual
Page 126
126
En
Using multi-zone configuration
■ Using REMOTE IN/OUT jacks for multi-zone components
This unit is equipped with two REMOTE IN and REMOTE OUT jacks. You can use these jacks to control this unit and
other components from Zone 2, Zone 3 or Zone 4. The following diagram shows an example of the connections.
y
Some Yamaha models are able to connect directly to the REMOTE jacks of this unit. If you own these products, you may not need to use
an infrared signal emitter. Up to 6 Yamaha components can be connected as shown below.
■ Using TRIGGER OUT jacks for multi-zone components
This unit is equipped with two TRIGGER OUT jacks. You can turn on and off the component corresponding to the
selection of the input source of the desired zone or turning on and off the desired zone by configuring the “Trigger
Output” settings (page 107).
REMOTE
IN
1
2
OUT
IN
OUT
This unit
Remote control
signal in
Remote control
signal in
DVD player (etc.)
CD player (etc.)
(Zone 2)
(Zone 3)
Infrared signal
receiver
Remote control
Remote control
signal out
Remote control
signal out
Remote
control
External amplifier
OUT
OUT
IN
REMOTE
IN
REMOTE
OUT
IN
REMOTE
REMOTE
This unit
Yamaha
component
Yamaha
component
Infrared signal
receiver
TRIGGER OUT
1
2
Power amplifier (etc.)
Zone 2 (etc.)
Trigger in
This unit
Trigger in
Projector (etc.) in the
main zone