Setting the speaker impedance and display language, Turning this unit on and off, Setting the speaker impedance and display – Yamaha RX-Z7 User Manual
Page 31: Language
31
En
Connections
PRE
P
ARA
T
ION
1
Make sure this unit is turned off.
2
Press and hold
N
STRAIGHT on the front
panel and then press B
MASTER ON/OFF
inward to the ON position.
This unit turns on, and the advanced setup menu
appears in the front panel display.
3
Rotate the M
PROGRAM selector to select
“SPEAKER IMP.”.
4
Press N
STRAIGHT repeatedly to select
“6
Ω MIN”.
5
Rotate the M
PROGRAM selector to select
“LANGUAGE”.
6
Press N
STRAIGHT to select desired
language setting for the GUI screen in the
video monitor.
Choices: ENGLISH (English),
JAPANESE (Japanese), FRENCH (French),
GERMAN (German), SPANISH (Spanish),
RUSSIAN (Russian)
• For details about the display language, see “Language”
• You can also select the display language with the GUI menu
7
Press B
MASTER ON/OFF to release it
outward to the OFF position to save the new
setting and turn off this unit.
The setting you made is reflected next time you turn on this
unit.
■ Turning on this unit
Press B
MASTER ON/OFF on the front panel
inward to the ON position.
When you turn on this unit by pressing BMASTER ON/
OFF, the main zone is turned on.
■ Turning off this unit
Press B
MASTER ON/OFF on the front panel
again to release it outward to the OFF position.
■ Set the main zone to the standby mode
Press A
MAIN ZONE ON/OFF
(or D
STANDBY).
■ Turning on the main zone from the
standby mode
Press A
MAIN ZONE ON/OFF (or EPOWER).
y
• Basically, we recommend that you use the standby mode to turn
off this unit. In the standby mode, this unit consumes a small
amount of power in order to receive infrared signals from the
remote control.
• Even when this unit is in the standby mode, power consumption
increases if “Standby Through” (page 101) or “Network
Standby” (page 102) is on. If you do not use this unit for long
periods of time, turn off this unit by pressing
BMASTER ON/
OFF to minimize power consumption.
•
AMAIN ZONE ON/OFF, DSTANDBY and EPOWER are
operational only when
BMASTER ON/OFF is pressed
inward to the ON position.
• When you turn on this unit, there will be a delay for a few
seconds before this unit can reproduce sound.
Setting the speaker impedance
and display language
Caution
If you are to use 6 ohm speakers, set “SPEAKER
IMP.” to “6
Ω MIN” as follows BEFORE using this
unit. You can also use 4 ohm speakers as the front
speakers (page 130).
Notes
Note
MASTER
EFFECT
STRAIGHT
While holding
down
Turning this unit on and off
If there are some problems...
• First, turn off and then turn on this unit again.
• If problems persist, initialize the parameters of this