Xantrex Technology 200 - Manual (Page 42)

Operation
3-16 975-0057-01-01
To inflate small sports equipment:
1. Place the valve connector fully on or into the valve
receptacle on the item. Go to Step 4.
OR
If necessary, use a supplied nozzle adaptor.
2. Choose the appropriate nozzle adaptor, insert the nozzle
adaptor into the valve stem and close the thumb latch.
3. Insert nozzle adaptor into the valve receptacle of the
item.
4. Turn the compressor on and inflate to appropriate
pressure.
5. Turn the compressor off before removing nozzle adaptor
from valve stem.
6. Remove nozzle adaptor from valve connector and store
in storage compartment.
CAUTION
The XPower Powerpack cannot be used to inflate
large capacity inflatables such as float tubes, large
air mattresses, and inflatable boats. These types of
products require extended inflating times which
may damage the compressor.
WARNING: Fire Hazard
Allow the compressor to cool down for 10 minutes
after each 10 minutes of continuous operation.
Note : Leave the thumb latch in the open position for
storing to relieve pressure on the internal mechanism.