ZyXEL Communications PRESTIGE 128MH - Manual (Page 108)

Prestige 128MH PSTN Router/Hub
6-8 Remote Node IPX Configuration
6.5.1 IPX Remote Node Setup
Follow the procedure in Chapter 5 to configure the protocol-independent parameters in Menu
11.1 - Remote Node Profile. For the IPX-specific parameters in Menu 11.3 - Remote Node
Network Layer Options, follow the instructions below. If you want the Prestige to receive
incoming calls, you must also configure the default dial-in parameters in Menu 13.
To edit Menu 11.3 - Remote Node Network Layer Options shown in Figure 6-4, follow these
steps:
Step 3. In Menu 11.1, make sure [IPX] is among the protocols in the Route field. (The Route
field should display Route = IPX or Route = IP + IPX.)
Step 4. Move the cursor to the [Edit IP/IPX/Bridge] field, then press the space bar to select
[Yes] and press [Enter]
to open Menu 11.3 - Network Layer Options.
Figure 6-4. Menu 11.3 - Remote Node Novell IPX Options
Menu 11.3 - Remote Node Network Layer Options
IP Options:
Rem IP Addr:
Rem Subnet Mask= N/A
My WAN Addr= N/A
Single User Account= N/A
Server IP Addr= N/A
Metric= N/A
Private= N/A
RIP Direction= N/A
Version= N/A
IPX Options:
Dial -On-Query= No
Rem LAN Net #= 00000000
My WAN Net #= 00000000
Hop Count= 1
Tick Count= 2
W/D Spoofing(min)= 3
SAP/RIP Timeout(min)= 3
Bridge Options:
Dial -On-Broadcast= N/A
Ethernet Addr Timeout(min)= N/A
Enter here to CONFIRM or ESC to CANCEL: