ZyXEL Communications PRESTIGE 128MH - Manual (Page 114)

Prestige 128MH PSTN Router/Hub
7-2 Bridging Setup
From Menu 3 - Ethernet Setup, enter option [4. Bridge Setup] and Menu 3.5 - Bridge Ethernet
Setup displays as shown in Figure 7-1.
Figure 7-1. Menu 3.5 - Bridge Ethernet Setup
Table 7-1 describes how to configure the [Handle IPX] field in Menu 3.5.
Table 7-1. Bridge Ethernet Setup Menu - Handle IPX Field Configuration
Handle IPX Field
(Menu 3.5)
Description
None When there is no IPX traffic on the LAN or when you do not want to apply
any special handling for IPX.
Client When there are only client workstations on the LAN. RIP and SAP (Service
Advertising Protocol) response packets will not trigger calls.
Server When there are only IPX servers on the LAN. No RIP or SAP packets will
trigger calls. In addition, during the time when the line is down, your Prestige
will reply to watchdog messages from the servers on behalf of remote clients.
The period of time that your Prestige will do this is linked to the [Ethernet
Address Timeout] parameter in each remote node (see Remote Node
Configuration). When a remote Ethernet address is aged out, there is no
need to main tain its connection to the IPX server.
If there are both clients and servers on the LAN, and the local clients will access the remote
servers, set this field to Server but turn on the
Dial-On-Broadcast parameter in Menu 11.3 to
allow the client queries to trigger calls.
Menu 3.5 - Bridge Ethernet Setup
Handle IPX= None
Press ENTER to CONFIRM or ESC to CANCEL:
Press Space Bar to Toggle.