Edimax Technology PS-1206UWg - Manual (Page 13)

8
1.6 Firmware & Printing Function
The print server provides a complete network printing
solution. The feature set is listed below:
PTPP (Peer-to-Peer-Printing)
TCP/IP (LPR)
IPP Printing
NetW are Bindery Printing
AppleTalk
SMB Printing
2. Hardware Installation
Unpack the print server package and verify that all the
items listed in the section 1.2 are provided.
Connect the print server to the printer you want to share on
the network.
Connect the print server to your network by attached the
network cable to the UTP port of the print server.
Connect the power adapter to the print server. The print
server will perform the Power-On-Self-Test (POST) after it
is powered on. During the POST, the Status and Ready
LEDs will be on. W hen the LEDs are unlighted, the print
server is ready.
NOTE1: MUST use the power adapter shipped with the print server, do
NOT use any other power adapter from any sources.
NOTE2: To prevent the compatibility problem between print server and
a few printer, it is recommended that you power on the print
server before the printer.