Husqvarna 122HD60 - Manual (Page 18)

18 – English
MAINTENANCE
Maintenance schedule
The following is a list of the maintenance that must be performed on the machine. Most of the items are described in the
Maintenance section. The user must only carry out the maintenance and service work described in this Operator’s
Manual. More extensive work must be carried out by an authorized service workshop.
Maintenance Before use:
After 40
hours in use After 100
hours in use
Clean the outside of the machine. After each time the machine is used
Make sure the throttle trigger lock and the throttle function correctly
from a safety point of view.
X
In order to reduce the risk of fire, dirt, leaves and surplus lubricant, etc
must be cleaned from the muffler, exhaust pipe and engine.
X
Check that the stop switch works correctly. X
Check that the blades do not move when the engine is idling. X
Check that the blades are undamaged and show no signs of cracking
or other damage. Replace the blades if necessary.
X
Check that the blade guard is not damaged or distorted. Replace the
blade if the blade guard is bent or damaged.
X
Replace the cutting unit if it is bent or damaged. X
Check that the hand guard is not damaged. Replace the guard if
damaged.
X
Check that nuts and screws are tight. X
Check that there are no fuel leaks from the engine, tank or fuel lines. X
Clean the air filter and oil it in.
Clean more often if conditions are exceptionally dusty.
(25 tim).
Check the starter and starter cord. X
Check that the vibration damping elements are not damaged. X
Clean the outside of the spark plug. Remove it and check the electrode
gap. Adjust the gap to 0.5 mm or replace the spark plug. Check that
the spark plug is fitted with a suppressor.
X
Clean the machine’s cooling system. X
Clean the outside of the carburettor and the space around it. X
Fill the gear housing with grease. This should be carried out
approximately every 25 working hours.
X
Check that the screws that hold the blades together are correctly
tightened.
X
Check and clean the spark arrestor mesh on the muffler (only applies
to mufflers fitted with a catalytic converter).
X
Clean the inside of the fuel tank. X
Check the inside of the fuel filter for any dirt or if the fuel hose has any
cracks or other defects. Replace if necessary.
X
Check all cables and connections. X
Check the clutch, clutch springs and the clutch drum for wear. Replace
if necessary by an autorized service workshop.
X
Replace the spark plug. Check that the spark plug is fitted with a
suppressor.
X
H1153993-26,122HD45,60#4ACBF.fm Page 18 Tuesday, January 4, 2011 8:31 AM