Warning – SUUNTO Vyper User Manual
Page 5
3
WARNING!
READ THIS MANUAL! Carefully read this instruction manual in its entirety,
including section 1.1. “Safety Precautions”. Make sure that you fully understand
the use, displays and limitations of the dive computer. Any confusion resulting
from improper use of this device may cause diver to commit errors that may
lead to serious injury or death.
WARNING!
ALWAYS ACTIVATE THE COMPUTER TO CHECK THE NO-FLYING
TIME REMAINING PRIOR TO FLYING. The computer goes into the stand-by
display automatically 5 minutes after the dive has ended. The stand-by display
shuts off after two hours. Failure to check the remaining no-fl ying time prior
to fl ying can greatly increase the risk of DCS.
WARNING!
IN THE DATA TRANSFER MODE THE DIVE MODE IS NOT AUTOMATI-
CALLY ACTIVATED. You must exit this mode before diving.
NOTE!
IT IS NOT POSSIBLE TO CHANGE BETWEEN THE AIR, NITROX AND
GAUGE MODES BEFORE THE INSTRUMENT HAS COUNTED DOWN
THE NO-FLYING TIME.
IF YOU DIVE WITH THE GAUGE MODE, IT IS NOT POSSIBLE TO
CHANGE BETWEEN THE MODES WITHIN 48 HOURS.
WHEN PLANNING SUBSEQUENT AIR AND NITROX DIVES DURING
THE SAME DIVE SERIES, YOU SHOULD HAVE THE DIVE COMPUTER
SET IN THE NITROX MODE AND MODIFY THE GAS MIX
ACCORDINGLY.