SUUNTO Advizor - Manual (Page 17)

11
1.6 PRESSURE SENSOR CALIBRATION
WARNING: This is a FACTORY CALIBRATION SETTING. Do not enter this mode.
If you enter this mode in error, exit immediately by pressing the [MODE] button to return to the “UNI” setting
mode. Normally there is no need to alter the calibration.
If the Pressure Setting Calibration has been altered, you can return the factory setting. Proceed as follows: In
the calibration setting mode, scroll the barometric pressure value up or down until text “dEF” appears. This is
the factory setting. Then exit by pressing [MODE].
1.7 CARE AND MAINTENANCE
Perform only the detailed processes discussed in this guide. Do not perform any other service to the Wristop Computer
or attempt to open the case or remove the buttons or the bezel.
Protect your Wristop Computer from shocks, extreme heat and prolonged exposure to direct sunlight. If not in use, your
Wristop Computer should be stored in a clean, dry environment at room temperature.
The Wristop Computer can be wiped clean with a lightly moistened (warm water) cloth. Applying a mild soap to the area
can clean stubborn stains or marks.
Avoid exposing the Wristop Computer to strong chemicals like gasoline, cleaning solvents, acetone, alcohol, adhesives,
and paint, as they will damage the unit’s seals, case and finish.
Never attempt to take the Wristop Computer apart or service it yourself. Make sure the area around the sensors (backside
of the instrument) is kept free of dirt and sand. Never insert any objects into the sensor openings of the Wristop Computer.
1.8 SERVICE
When your Wristop Computer needs service, follow the instructions mentioned below.
SENDING INSTRUCTIONS
1. Pack the product carefully to avoid damage.
2. Include both the Wristop Computer and the transmitter belt. A full periodic check will be done on the whole product.