Accusys ExaSAN SW16 - Manual (Page 17)

1. Introduction
User Guide Page 1-7
Figure 8: SW16 packing list
1.2.1 What Is In Your Order
Your ExaSAN System Integrator/Value Added Reseller should have helped you assess,
identify, and order all necessary system components and accessories not included in
the SW16 packaging. If you ordered the complete SW16 system solution, your order
includes everything described in Section 1.3.
There are generic system components and accessories required by the ExaSAN solution
but not included. Please refer to Section 1.5, “What Else You Need” for additional
information.
1.2.2 Checking the Equipment you’ll need
Section 1.1.3 has a hardware list of all the equipment you’ll need to set up the ExaSAN
SAN environment. Check carefully against that list; verify that you have all of the system
components and accessories before commencing hardware installation.
1.2.3 Unpacking
Follow the steps below to open the carton and remove the system from its packaging. .
1. Read Chapter 2, “Preparing to Install ExaSAN SW16”
2. Remove any packing material on the outside of the carton.
3. Cut the tape at the top of the carton. If you use a long cutting instrument, exercise
care to avoid damaging the content inside.
4. Open up the top flaps of the carton to reveal the content inside. Remove the
protective foam on top of the system. Carefully remove each item from inside the
carton.