Tyco Electronics FOSC-400D5 - Manual (Page 10)

6.3 Place oval seal over the oval port and
cable. Mark the sleeve length onto the cable.
6.4 Match the blue line of the aluminium
cable protection foil with the marks on the
cables. Wrap aluminium cable protection foil
around cable.
6.5 Slide the oval cable seal over the oval
port. Install the branch-off clip. Check that the
heat-shrinkable sleeve butts up against the
FOSC-base and the branch-off clip is
completely inserted. Tape the two cables
together.
6.6 Shrink the oval cable seal on the FOSC-
base side with the recommended hot air gun
device with reflector. Shrink sleeve until the
green thermo-indicating paint is
converted to black. (Make sure the hot-air tem-
perature is at least 350°C).
(If a FACC-HEAT-GUN-220V is used, set posi-
tion on scale 10).