Tyco Electronics FOSC-400D5 - Manual (Page 11)

6.7 Shrink down the end of the sleeve on
the cable side. Heat until the sleeve shrinks
down on the cables and take care that the
green thermo-indicating paint is converted to
black. Postheat the clip on both sides till the
adhesive shows a proper flow on the clip
between the two cables.
Wait until the sleeve is cool to the touch
before moving the cables.
7.1 Lift the top tray to expose the bottom
tray, which should be filled first. Use the tray
support wedge attached to the bottom of the
second tray to hold it out of the way.
7.2 Route the distribution tubes around the tray holding bracket so that they will reach the dis-
tribution side of the tray.
7.3 Remove the tray cover and align the transportation tubes along the outer sides of the tray.
7.4 Place a pen mark on each tube 5 mm
beyond the tie-down slots. Use a buffer tube
cutter to cut each tube at the mark, and remove
the excess tube from each fiber group. Clean
the fibers from the grease.
7 Positioning the transportation tubes and fibers
Tray support latch
Pen mark
Distribution
Feeder