Tyco Electronics FOSC-400D5 - Manual (Page 7)

3 General precautions
3.1 Do not use damaged sleeve nor trim heat-shrinkable sleeve before installation.
3.2 The FOSC-400D5 closures can be installed at temperatures between -1°C and +45°C.
3.3 Generators used should have enough capacity for the hot air gun utilisation.
Optical fiber infrastructure network elements may contain end of optical fiber attached to the
optical output when the device is operational. Laser radiation can seriously damage your eye-
sight. Please follow your local safety guidelines.
4.1 Attach the closure in the FOSC work
stand using the nut and the bolt. Loose and
remove the clamp.
Push the lever down to release the locking tab.
Open the clamp lever and release the clamp
using the lever legs. Remove the dome, the
sealing ring and store carefully for later use.
4.2 Open the oval port for cable entry by
cutting the port at the ridge with a hacksaw.
Deburr the inner edge of the port opening with
abrasive strip.
4.3 Remove any dirt, mud or other
contaminants from the cable sheath for
approximately 2 meters with a clean cloth. Take
the oval cable seal and slide it over the cables.
The non-coated edge of the sleeve and the
arrows should be pointed to the base of the
closure.
4 Cable installation in oval outlet