Tyco Electronics FOSC-400D5 - Manual (Page 12)

7.5 Secure the transportation tubes to the
tray with tie wraps as shown.
7.6 Arrange the fiber around the tray for storage until the fiber is to be spliced.
7.7 When all fibers to be stored in this tray have been arranged, replace the tray cover.
7.8 Repeat steps 7.1 through 7.7 for each tray until all fiber has been stored in a tray.
8.1 To add splice trays, put the tray support
latch down, hold the tray vertically over the tray
holder bracket, and insert the tray hinge into the
next unoccupied slot on the tray
holder bracket. Put the tray support latch up to
lower the tray.
9.1 Fiber placed on one tray can be spliced
with fiber from another tray by using an
intertray jumper to route the fiber to the
desired tray.
8.2 To remove splice trays from the FOSC-400D base, raise the tray and put the tray
support latch down. Pull the tray hinge out of the tray holder bracket, releasing the tray.
Tray support
latch
Intertray
jumper
9 Intertray jumpers
8 Add or remove splices trays