Tyco Electronics FOSC-400D5 - Manual (Page 9)

5.4 Align cable ring cuts with edge of base.
Slide strength members into clamps and
tighten. Cut away the excess length of strength
member.
5.5 If required, connect shield continuity
wire of both cables with shield continuity clip.
Talk pairs, if present, will be connected together
according to the local procedures.
6.1 Thoroughly clean oval port and cable
sheath with the cleaning tissue over a
distance of 100 mm from the edge of the port.
6.2 Abrade oval port and cable sheath
circumferentially on the cleaned area with the
abrasive strip. Remove any abraded material
with a clean cloth.
6 Sealing of oval outlet