Acnodes RMC 5018 - Manual (Page 21)

RMC 5018
1U Rackmount System
© Copyright 2011 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com. 14628 Central Blvd,
Chino, CA91710
tel:909.597.7588, fax:909.597.1939
2-6 Checking the Drive Bay Setup
Next, you should check to make sure the drives have been properly installed and all essential connections
have been made.
Checking the Drives
1. Refer to Chapter 6 if you need to reinstall a DVD-ROM drive to the system.
2. Depending upon your system's configuration, your system may have one or two Serial ATA drives
already installed. If you need to install Serial ATA drives ,please refer to the appropriate section in Chapter
6.
Providing Power
1. The last thing you must do is to provide input power to the system. Plug the power cord from the power
supply unit into a high-quality power strip that of- fers protection from electrical noise and power surges. It is
recommended that you use an uninterruptible power supply (UPS).
2. Finish by depressing the power button on the chassis control panel.