Acnodes RMC 5018 - Manual (Page 63)

RMC 5018
1U Rackmount System
© Copyright 2011 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com. 14628 Central Blvd,
Chino, CA91710
tel:909.597.7588, fax:909.597.1939
XAdvanced Chipset Control
The items included in the Advanced Settings submenu are listed below:
XNorthBridge Configuration
This feature allows the user to configure the settings for the Intel 945GC North- Bridge.
DRAM Frequency
This feature allows the user to select the DRAM Frequency setting. The options are Auto (Auto-detect),
400 MHz and 533 MHz.
Configure DRAM Timing by SPD
Select Enable to allow the BIOS to read the SPD (Serial Presence Detect) chip which is built in the
memory module in order to get the exact memory specifica- tions. The options are Enabled and Dis-
abled.
DRAM CAS# Latency
The options are [3], [4], [5], and [6]
DRAM RAS# to CAS# Delay
The options are 3 DRAM Clocks, 4 DRAM Clocks, 5 DRAM Clocks, and 6 DRAM Clocks.
DRAM RAS# Precharge
The options are 3 DRAM Clocks, 4 DRAM Clocks, 5 DRAM Clocks, and 6 DRAM Clocks.
DRAM RAS# Activate to Precharge
The options are 9 DRAM Clocks, 10 DRAM Clocks, 11 DRAM Clocks, 12 DRAM Clocks, 13 DRAM
Clocks, 14 DRAM Clocks, and 15 DRAM Clocks.
Initiate Graphic Adapter
Use the feature to select the graphics controller to be used as the primary boot device. The options
are IGD, PCI/IGD, PCI/PEG, PEG/IGD, and PEG/PCI.
Internal Graphics Device Mode Select
Use the feature to set the amount of system memory to be used by the Internal Graphics Devices. The
options are Disabled, Enabled, 1 MB and Enabled, 8 MB.