Acnodes RMC 5018 - Manual (Page 45)

RMC 5018
1U Rackmount System
© Copyright 2011 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com. 14628 Central Blvd,
Chino, CA91710
tel:909.597.7588, fax:909.597.1939
SMB (I2C) Bus to PCI Slots
Jumpers JI2C1 and JI2C2 allow you to connect the
System Management Bus (SMB) to the PCI-E PCI slot.
The default setting is Disabled. See table on the right for
jumper settings.
TPM Support Enable
JPT1 allows the user to enable TPM (Trusted Platform
Module) support to enhance data integrity and system
security. See the table on the right for jumper settings.
The default setting is Enabled.
Watch Dog Enable/Disable
Watch Dog (JWD) is a system monitor that can reboot
the system when a software application hangs. Close
pins
1~2 to reset the system if an applica- tion hangs. Close
pins 2~3 to generate a non-maskable interrupt signal
for the application that hangs. See the table on the right
for jumper settings. Watch Dog must also be enabled in
the BIOS.
Power Force On Enable/Disable
Jumper JPF allows you to enable or disable the Power
Force On function. If enabled, the power will always stay
on automatically. If this function is disabled (the normal
setting), the user needs to press the power button to
power on the system.
VGA Enable/Disable
JPG1 allows the user to enable the onboard VGA con-
nector. Close Pins 1~2 to use this function. The default
setting is Enabled.