Acnodes RMC 5018 - Manual (Page 55)

© Copyright 2011 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com. 14628 Central Blvd,
Chino, CA91710
tel:909.597.7588, fax:909.597.1939
RMC 5018
1U Rackmount System
6-5 Power Supply
The RMC5018 chassis has a single 200 watt power supply. This power supply is auto-switching ca-
pable. This enables it to automatically sense and operate at a 100v to 240v input voltage.
In the event that the power supply unit fails, the system will shut down and you will need to change the
power supply unit. New units can be ordered directly from Acnodes (see contact information in the
Preface).
Replacing the Power Supply (Figure 6-5)
1. Power down the system and unplug the AC power cord.
2. Disconnect all wiring from the power supply.
3. Remove the four screws that secure the power supply to the chassis and extend upwards through
the mounting thru holes, to hold the power supply in place (two mounting screws are located on the rear
of the power supply and two mounting screws are accessed on the underside of the chassis). Set the
screws aside for later use.
4. Remove the power supply from the chassis.
5. Align the mounting thru holes on the power supply with the mounting holes in the chassis and reat-
tach the power supply to the chassis using the four screws which were previously set aside
6. Connect the chassis wiring to the power supply.
7. Replace the top cover, reattach the AC power cord and power up the system.