Activeforever Invacare Pronto M41 Power Wheelchair with Semi Recline Seat - Manual (Page 40)

SECTION 9—FOOTBOARD ASSEMBLY
Pronto® M41 with SureStep® 40 Part No. 1143206
SECTION 9—FOOTBOARD
ASSEMBLY
ƽ WARNING
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that on/off switch
on the joystick is in the off position.
DO NOT stand on the flip-up footboard. When getting in or out of the wheelchair,
make sure that the flip-up footboard is in the upward position.
Limited Clearance Between Footboard and Caster - The user’s feet MUST
remain centered on the footboard, away from the footboard sides, while operating
the wheelchair. If the user’s feet are allowed to rest off the side of the footboard
they may come in contact with the caster possibly resulting in injury.
Removing/Installing the Footboard Assembly
ƽ WARNING
Pinch point may occur when adjusting the footboard.
NOTE: For this procedure, refer to FIGURE 9.1 on page 41.
Removing
1. Remove the quick release pin that secures the footboard assembly to the wheelchair
frame by depressing the button while sliding the pin out.
2. Remove the footboard assembly from the wheelchair frame.
Installing
ƽ WARNING
Make sure the detent balls of the quick-release pin are fully released beyond the
outer edge of the tube before operating the wheelchair. Otherwise, injury and/or
damage may result.
Keep detent balls clean.
1. Position the footboard assembly onto the wheelchair frame so that the mounting hole in
the wheelchair frame aligns with the desired mounting hole in the footboard assembly.
2. Install the quick release pin by depressing the button while sliding the pin in. Ensure that
the detent balls are engaged with the outer edge of the tube (Detail “A” of FIGURE 9.1).