Adjusting the footboard assembly, Angle – Activeforever Invacare Pronto M41 Power Wheelchair with Semi Recline Seat User Manual
Page 41
SECTION 9—FOOTBOARD ASSEMBLY
Part No. 1143206
41
FIGURE 9.1 Removing/Installing the Footboard Assembly
Adjusting the Footboard Assembly
Angle
NOTE: For this procedure, refer to FIGURE 9.2.
1. Loosen the jam nut and set screw located underneath on the backside of the footplate.
2. Adjust the set screw in or out to obtain the desired footboard assembly angle.
3. Thread the jam nut and washer inward until it is flush with the footboard bracket.
4. Securely tighten the jam nut and washer to secure the mounting screw in place.
FIGURE 9.2 Adjusting the Footboard Assembly - Angle
Quick Release Pin
Detent
Ball
Footboard
Assembly
Mounting
Hole
Shroud
DETAIL “A” - TOP VIEW
OF FOOTBOARD
Quick
Release Pin
Outer Edge of Tube
Detent Balls
Set Screw, Washer
and Jam Nut
Footboard Assembly