Activeforever Invacare Pronto M41 Power Wheelchair with Semi Recline Seat - Manual (Page 46)

SECTION 10—FRONT RIGGINGS
Pronto® M41 with SureStep® 46 Part No. 1143206
Model PH904A and PHAL4A
NOTE: For this procedure, refer to FIGURE 10.3.
NOTE: PH904A style front rigging shown. PHAL4A front rigging adjust the same way.
1. Loosen, but do not remove the lug bolt
and locknut that secure the lower
footrest to the footrest support.
2. Reposition the lower footrest to the
desired height.
3. Securely tighten the lug bolt and
locknut that secure the lower footrest to
the footrest support.
4. Repeat STEPS 1‐3 for the opposite side
of the wheelchair footrest, if necessary.
FIGURE 10.3 Adjusting Footrest Height -
Model PH904A and PHAL4A
Replacing Heel Loops
NOTE: For this procedure, refer to FIGURE 10.4.
1. Note the position of hex bolt, coved
washers and locknut for reinstallation.
2. Remove the hex bolt, coved washers
and locknut that secure the lower
footrest to the footrest support.
3. Remove the lower footrest.
4. Remove the phillips ® bolt, spacer and
locknut that secure the existing heel
loop to the lower footrest.
5. Slide the existing heel loop off the
lower footrest.
6. Replace heel loop.
7. Reverse STEPS 1‐6 to reassemble.
FIGURE 10.4 Replacing Heel Loops
NOTE: When securing heel loop to lower footrest, tighten the phillips screw and locknut until the
spacer is secure.
Locknut
Footrest
Support
Lower
Footrest
Lug Bolt
Coved
Washer
Hex Bolt
Footrest
Support
Coved
Washer
Locknut
Lower
Footrest
Phillips
Bolt
Locknut
Spacer
Heel Loop
Locknut