Activeforever Invacare Pronto M41 Power Wheelchair with Semi Recline Seat - Manual (Page 58)

SECTION 13—BATTERIES
Pronto® M41 with SureStep® 58 Part No. 1143206
SECTION 13—BATTERIES
Warnings For Handling and Replacing Batteries
ƽ WARNING
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that On/Off
switch on the joystick is in the Off position.
Most batteries are not sold with instructions. However, warnings are frequently
noted on the cell caps. Read them carefully, otherwise serious injury or damage may
occur.
Invacare strongly recommends that battery installation and battery replacement
ALWAYS be done by a qualified technician.
ALWAYS transport the battery pack/box in an upright and secure manner. To
prevent damage, do not transport the battery pack/box with other objects that
could suddenly shift during transportation, unless they are secured or in a different
vehicle area. DO NOT transport battery pack/box with gas cans or similar
containers in the same vehicle area.
DO NOT tip the batteries. Keep the batteries in an upright position.
NEVER allow any of your tools and/or battery cable(s) to contact both battery posts
at the same time. An electrical short may occur and serious personal injury or
damage may occur.
The POSITIVE (+) RED battery cable must connect to the POSITIVE (+) battery
terminal, otherwise serious damage will occur to the electrical system.
NOTE: If there is battery acid in the bottom of the battery tray or on the sides of the battery(ies),
apply baking soda to these areas to neutralize the battery acid. Before reinstalling the existing or
new battery(ies), clean the baking soda from the battery tray or battery(ies) being sure to avoid
contact with skin and eyes. Determine source of contamination. Never install/reinstall a battery
with a cracked or otherwise damaged case.
Using the Proper Batteries
1. Place battery on ground/flat surface.
2. Visually draw a horizontal and vertical centerline through the middle of battery.
3. Position the battery so that the terminals are above the horizontal centerline.
4. Visually inspect the battery to ensure the correct position of the POSITIVE and
NEGATIVE terminals.