Activeforever Invacare Pronto M41 Power Wheelchair with Semi Recline Seat - Manual (Page 49)

SECTION 11—SHROUD AND WHEELS
Part No. 1143206 49 Pronto® M41 with SureStep®
SECTION 11—SHROUD AND
WHEELS
ƽ WARNING
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that on/off switch
on the joystick is in the off position.
Replacing the Flat Free Tires on the Wheel Rim
ƽ WARNING
DO NOT attempt to replace flat free tires. This procedure MUST be performed by
a qualified technician.
NOTE: During initial use of the wheelchair, the user may experience flat spots on the wheels. Flat
spots will vanish with continued use of the wheelchair.
Removing/Installing the Top Shroud
NOTE: For this procedure, refer to FIGURE 11.1 on page 50.
NOTE: The top shroud cannot be completely removed from the wheelchair without disconnecting
the joystick cable. If it is necessary, refer to Disconnecting/Connecting the Joystick on page 56
to remove the top shroud from the wheelchair.
Removing
1. Remove the seat. Refer to Removing/Installing the Seat Assembly on page 37.
2. Remove the four mounting screws that secure the top shroud to the wheelchair frame.
Installing
1. If necessary connect the joystick cable to the batteries and or the right and left motors.
2. Position the top shroud onto the wheelchair frame.
3. Using the four mounting screws, secure the top shroud to the wheelchair frame.
4. Install the seat. Refer to Removing/Installing the Seat Assembly on page 37.