SUUNTO X10 - Manual (Page 15)

14
3.2.2. Stopwatch
To use the stopwatch:
1.Select the stopwatch shortcut with STOP/BACK.
2.Press START/DATA to start the stopwatch. If you want to
record a split time, press START/DATA again. The split time
stays on the display for three (3) seconds. Then Suunto X10
returns to showing the running time.
3.Press STOP/BACK to stop the stopwatch. If you have
recorded any split times, you can now scroll them with STOP/
BACK.
4.To reset the timer, long press STOP/BACK. If the stopwatch
has not been reset after stopping the timing, press START/
DATA to continue the timing from the end time.
Suunto X10 can display up to 29 split times.
NOTE: When you have used the stopwatch, you cannot select other shortcuts before
resetting the timer.
NOTE: The maximum time period you can record with the stopwatch is 20 hours.
3.2.3. Alarm
You can set three independent time alarms. When the alarm is set, the time alarm
symbol appears on the main display.
Activating alarms
To activate an alarm:
1.In the Set menu, Alarm is the first menu item. Press ENTER
to select it. The Alarm menu displays the status of the alarms.
When you open the menu for the first time, the alarm
indicators are set to Off as default.
NOTE: You can check the times of sunrise and sunset for
reference with START/DATA, in the Alarm List Display. For
more information on this, see section 3.3.4. Alti/Baro data
display.
2.Scroll to the alarm you want to set and press ENTER. The
On/Off field is activated.
3.Press either the UP or DOWN button to change the alarm
status to On. Press ENTER. The hour selection is activated.