SUUNTO X10 - Manual (Page 42)

41
Viewing waypoints
To view waypoints:
1. In the Set menu, scroll to Route and press ENTER. The
route list is displayed.
2. Select a route with UP/DOWN and press ENTER. A list of
waypoints is displayed.
3. Select a waypoint with UP/DOWN and press ENTER. The
waypoint menu is displayed.
4. View is the first menu item. Press ENTER to select it. The
following waypoint information is displayed:
• Waypoint number: This tells you the waypoint order on
the route.
• Bearing and distance to the waypoint: These are
calculated from the current location or if the GPS is off,
from the previous location.
• Waypoint coordinates: The coordinates of the selected
waypoint.
NOTE: The information on the waypoint window differs depending on the chosen
Position format. (For more information, see section 3.2.6. Setting the position
format.)
You can also activate an additional data display with
START/DATA. The following information is displayed:
• Point type:
= Waypoint and = alarm point
• Waypoint alarm radius (RAD): This is only used with
alarm points. If the alarm radius is 0, the alarm is not
activated.
Press START/DATA to exit the additional data display.
5. Press STOP/BACK to exit the waypoint information and
return to the waypoint list.