Soft dB Tenor 24bits Data User Guide - Manual (Page 53)

Tenor Data Logger Soft dB inc.
Appendix A: Tenor Driver and Software Installation Procedure
!
The Tenor unit is not automatically recognized by
Windows.
Follow each step below precisely to ensure proper
installation of the system.
1) Execute the Tenor24Bit_DataLoggerVer2_0.exe file (see installation disk provided with
the Tenor).
2) Follow the installation procedure. By default, the Tenor software is installed in the
C:\Program Files\Tenor_24Bit directory. Do not launch the software at this point; the
USB driver has to be installed beforehand.
3) Apply power to the Tenor unit (input 12VDC in the rear of the unit). Use the power pack
provided by Soft dB. The Status Board LED of the Tenor unit should turn yellow.
4) Connect the USB cable to the un25it (USB input on the rear of the Tenor unit).
5) Connect the other end of the USB cable to the USB port of your PC.
Windows indicates that a new peripheral has been detected. Follow the procedure
below:
Check No, not this time and then click on Next
User Manual p. 53