Soft dB Tenor 24bits Data User Guide - Manual (Page 9)

Tenor Data Logger Soft dB inc.
4.0 Using the acquisition software
The next paragraphs present the set-up and acquisition portions of the software. The
instrument set-up functions and the acquisition interface will be presented in detail. Post-
processing functions are not covered in this section (this information is covered in section
5.0).
4.1 Launching the Tenor software
Connect the power supply to the Tenor unit using the “12Vdc/2.0A” connector at the rear
of the unit. Connect the Tenor unit to a computer using a USB cable. The Board Status
LED on the rear of the Tenor unit should turn green.
Select and launch the Tenor_24Bit software via the Windows menu, or at the default
directory C:\Program Files\Tenor_24Bit.
User Manual p. 9