Spicer Single Drive Axles Service Manual: 34DS, 34RS, 38DS, 38RS, DS340, RS340, DS380, RS380, DS400, RS400, DS3 - Manual (Page 46)

Power Divider Replacement
43
5. Make certain dowel pins are installed in carrier (see draw-
ing above), then install power divider assembly.
Use a transmission jack or a chain hoist and sling (see
photo).
During installation, rotate input shaft to engage input shaft
splines with inter-axle differential, After installation, again
rotate input shaft to check for correct assembly. Output
shaft should turn when input shaft is rotated.
Procedure - Installing Power Divider Assembly with
Chain Hoist and Sling.
1. Install power divider cover cap screws and lock washers.
On pump models only, install socket-head cap screw in
correct location (see drawing on preceding page). Torque
cap screw to 110-125 ft. lbs. (149-170 N.m).
2. Check and Adjust Input Shaft End Play- With power divid-
er assembled to differential carrier. Check end play with
dial indicator. If necessary, adjust end play. After input
shaft end play is within specifications, complete assembly
procedure as follows:
3. Measuring Input Shaft End Play with Dial Indicator.
4. Connect drivelines. Connect lockout air line.
5. Fill axle to proper lube level (see Lubrication Section).
When axle has been disassembled or housing, gears,
axle shafts or wheel equipment replaced, check axle as-
sembly for proper differential action before operating
vehicle. Wheels must rotate freely and independently.
*Washer not used on axles with metric threaded nuts.
Installing Power Divider Assembly with Chain Hoist and
Sling
Measuring Input shaft End Play with Dial Indicator
Pry bar
U-bracket
Dial indicator
Input shaf
Lift up on
pry bar to
compress
input shaft.
IMPORTANT