Spicer Single Drive Axles Service Manual: 34DS, 34RS, 38DS, 38RS, DS340, RS340, DS380, RS380, DS400, RS400, DS3 - Manual (Page 63)

Power Divider Overhaul
60
Ser
vice Procedure
4. Apply silicone gasket compound on carrier mating surface
(see illustration).
5. Install Power Divider. Attach chain hoist to input yoke and
install power divider assembly During installation, rotate in-
put shaft to engage input shaft splines with inter-axle differ-
ential. After installation, again rotate input shaft. Output
shaft should turn when input shaft is rotated if assembly is
correct.
Note: Lifting mechanism may create nicks and burrs on in-
put yoke. Remove if present.
6. If removed, install dowel pins in carrier. Install power divider
cover cap screws and lock-washers. (On pump models only,
place socket-head cap screw at location shown on drawing.
Torque cap screws to 110-125 ft. lbs. (149-170 N.m).
7. Adjust Input Shaft End Play. Adjust end play with the power
divider assembled to the differential carrier. (See page 39.)
Dowel Pin
Dowel Pin
Socket Head
Capscrew
P ower D ivider C over
D owel P in L ocation
Silicone Gasket Compound