Spicer Single Drive Axles Service Manual: 34DS, 34RS, 38DS, 38RS, DS340, RS340, DS380, RS380, DS400, RS400, DS3 User Manual
Page 84
Differential Carrier Overhaul (Forward and Rear Axle)
81
8.
Rear Axle Only. With pinion installed and bearing preload ad-
justment complete, Install oil seal with a press. **
9.
Rear Axle Only. Prior to installation of yoke, lubricate oil seal
and make sure yoke is clean and dry. Install yoke, flat wash-
er* and nut. Torque nut to proper specification. (see page
24).
Note: After tightening pinion nut, recheck pinion bearing
rolling torque. See Adjustment Section for "Press-fit"
outer pinion bearing.
10. Forward Axle Pinion Helical Gear and Nut: These parts are in-
stalled during pinion installation (see page 53).
**Refer to page 13 for service information on Seals,
Yokes & Slingers.
* Nuts used on production axles after 1/3/95 are metric and
do not use flat washer.
Rear Axle Pinion.
Press Oil Seal
in Cage
(with pinion
installed
IMPORTANT