Spicer Single Drive Axles Service Manual: 34DS, 34RS, 38DS, 38RS, DS340, RS340, DS380, RS380, DS400, RS400, DS3 - Manual (Page 62)

Power Divider Overhaul
59
Install Power Divider on Differential Carrier (with carrier removed from axle housing)
Special Instructions
Note: The following instructions pertain to installation of power divider on differential carrier with carrier removed from axle hous-
ing.
Note: Before installing power divider, install related parts as follows
Procedure -
1. Output Shaft Side Gear Bearing Cup. If removed, press bear-
ing cup in carrier. Use a press and appropriate sleeve or use
a brass drift and a mallet. Tap bearing cup into its' bore mak-
ing certain cup is evenly and firmly seated.
Note: Late Model Axles may be equipped with a spring and
thrust button mounted between the input shaft and
output shaft (see page 54).
2. Output Shaft. Lubricate "O" rings, then install output shaft
assembly in carrier.
3. Inter-axle Differential. Install differential assembly on output
shaft side gear (with nuts facing away from output shaft side
gear).