Disassembly drive pinion – Spicer Single Drive Axles Service Manual: 34DS, 34RS, 38DS, 38RS, DS340, RS340, DS380, RS380, DS400, RS400, DS3 User Manual
Page 74
Differential Carrier Overhaul (Forward and Rear Axle)
71
Disassembly Drive Pinion
Note: Dana drive axles may be equipped with either slip-fit or press-fit outer pinion bearings. Procedures are contained in-this
section for disassembly of both types.
1
2
3
4
5
6
8
9
10
12
13
7
11
14
15
16
1
Pinion pilot bearing
2 Drive
Pinion
3
Bearing cone (inner)
4 Spacer
washer
5
Bearing spacer (variable)
6
Bearing cup (inner)
7 Lockwasher
8
Bearing cage shim
9 Bearing
cage
10
Bearing cup (outer)
11 Cage
capscrew
12
Bearing cone (outer)
13 Oil
seal
14 Input
yoke
15 Flat
washer
16 Pinion
nut
Rear Axle Pinion Illustrated.
Forward Axle Pinion Illustrated.
ïD341, 381(P), 401-P, 402(P), 403(P), 451-P use self-locking or slotted nut and roll pm.
Metric self-locking nuts used as of 1-3-95.
D340, 380(P), 400-P use self-locking nut only.